 |
|
|
 |
|
 |
|
|
|
|
|
|
|
|
PTC-RADON-GAS-KIT |
|
|
|
Radon Gas Test Kit |
|
|
|
|
|
$12.95 |
|
|
|
|
|
|
|
DIRECTIONS
Important Note: Please follow the directions carefully. Save the Radon Detector caps, directions and mailing materials. You will need them to send your detectors to our laboratory at the end of the testing period. In the space provided below, record the serial numbers located on the side of the Radon Gas Detectors and record the date you returned the detectors back to the lab. We will need this information should you have any questions about your test results.
PREPARING FOR TEST:
Close all windows and doors for at least 12 hours prior to the start of the test. You must keep them closed as much as possible during the testing. The less fresh air that enters the testing area, the more accurate your results. Do not operate fans or ventilation systems that use outside air such as attic and bathroom fans. NOTE: Outside weather conditions can affect testing. Testing should not be done during major weather events such as high winds and/or heavy rains. Rapid changes in barometric pressure can affect radon levels. If a radon mitigation system is present, it must be operating during testing.
SELECTING TEST LOCATIONS:
According to the EPA, radon testing should be conducted in the lowest livable area of your home. Make sure your test location is a room where the PRO-LABĒ Professional Radon Gas Detectors will not be exposed to drafts from vents, doors or windows. Do not place the detectors in a kitchen, bathroom or laundry room. Do not place the detectors in direct sunlight or near any heat source such as a fireplace or heater.
BEGINNING TEST:
Remove the caps from the two (2) detectors. Place the two (2) un-capped detectors on a flat surface at least 2-3 feet above the floor and 2-3 feet from any outside wall. The detectors should be placed 6 inches apart from each other. Allow the Radon Gas Detectors to remain un-capped for 4 days (96 hours). Once the Radon Gas Detectors have been placed, do not remove them until the entire (96 hour) testing period is complete.
FILLING OUT THE RADON DATA CARD:
Record the radon unit serial numbers, your name, address, test location, the date and exact time you started the test. After filling out this information, put the radon data card and the detector caps in a safe place. You will need them in order to complete the test.
ENDING TEST:
Replace the caps on the two (2) detectors and record the date and the exact time the testing ended on the Radon Data Card. Make sure your data card is now completely filled out. (If you leave out any information, your detectors will not be analyzed)
Standard Lab Results
Place the two (2) Radon Gas Detectors, the radon data card and a check, money order or a credit card voucher for $30.00 (Visa, MasterCard, AMEX or Discover Card) in the enclosed pre-paid postage envelope and mail immediately (within 24 hours of the completion of the test).
Within 1 week after the Lab has received your Radon Gas Detectors, we will send you an easy to read evaluation of the exact radon gas levels in your home or office.
Special Note: If you are a New Jersey resident, you must add an additional $10.00 fee for the New Jersey Department of Environmental Protection Agency's Administrative Costs.
|
|
|
|
|
|
|
|
|
|